#5621: refactor description of how class/instance attributes interact on a.x=a.x...

diff --git a/Doc/reference/simple_stmts.rst b/Doc/reference/simple_stmts.rst
index b92628329c794080e4380aadc226adabc16764e6..3886601f77009130069dd675cb2beb9a3c9ce1ae 100644 (file)
--- a/Doc/reference/simple_stmts.rst
+++ b/Doc/reference/simple_stmts.rst
@@ -151,11 +151,30 @@ Assignment of an object to a single target is recursively defined as follows.
 
 * If the target is an attribute reference: The primary expression in the
   reference is evaluated.  It should yield an object with assignable attributes;
-  if this is not the case, :exc:`TypeError` is raised.  That object is then asked
-  to assign the assigned object to the given attribute; if it cannot perform the
-  assignment, it raises an exception (usually but not necessarily
+  if this is not the case, :exc:`TypeError` is raised.  That object is then
+  asked to assign the assigned object to the given attribute; if it cannot
+  perform the assignment, it raises an exception (usually but not necessarily
   :exc:`AttributeError`).
 
+  .. _attr-target-note:
+
+  Note: If the object is a class instance and the attribute reference occurs on
+  both sides of the assignment operator, the RHS expression, ``a.x`` can access
+  either an instance attribute or (if no instance attribute exists) a class
+  attribute.  The LHS target ``a.x`` is always set as an instance attribute,
+  creating it if necessary.  Thus, the two occurrences of ``a.x`` do not
+  necessarily refer to the same attribute: if the RHS expression refers to a
+  class attribute, the LHS creates a new instance attribute as the target of the
+  assignment::
+
+     class Cls:
+         x = 3             # class variable
+     inst = Cls()
+     inst.x = inst.x + 1   # writes inst.x as 4 leaving Cls.x as 3
+
+  This description does not necessarily apply to descriptor attributes, such as
+  properties created with :func:`property`.
+
   .. index::
      pair: subscription; assignment
      object: mutable
@@ -253,16 +272,8 @@ same way as normal assignments. Similarly, with the exception of the possible
 *in-place* behavior, the binary operation performed by augmented assignment is
 the same as the normal binary operations.
 
-For targets which are attribute references, the initial value is retrieved with
-a :meth:`getattr` and the result is assigned with a :meth:`setattr`.  Notice
-that the two methods do not necessarily refer to the same variable.  When
-:meth:`getattr` refers to a class variable, :meth:`setattr` still writes to an
-instance variable. For example::
-
-   class A:
-       x = 3    # class variable
-   a = A()
-   a.x += 1     # writes a.x as 4 leaving A.x as 3
+For targets which are attribute references, the same :ref:`caveat about class
+and instance attributes <attr-target-note>` applies as for regular assignments.
 
 
 .. _assert: