esp32: Add reset uart

Fixed the case when the first part of log was missed
this was happened when:
 * CONFIG_CONSOLE_UART_CUSTOM option is selected (UART1)
 * The selected CONSOLE_UART port is used also for the console component
 * in code esp_restart() or abort() functions were called.

diff --git a/components/bootloader_support/src/bootloader_init.c b/components/bootloader_support/src/bootloader_init.c
index 8d3f33269c260fbd93a37b9f1d683f6902724918..295f11c322dd31ed517d3c4e2b4ab9a0f04cb9ba 100644 (file)
--- a/components/bootloader_support/src/bootloader_init.c
+++ b/components/bootloader_support/src/bootloader_init.c
@@ -426,6 +426,7 @@ static void uart_console_configure(void)
         // (arrays should be optimized away by the compiler)
         const uint32_t tx_idx_list[3] = { U0TXD_OUT_IDX, U1TXD_OUT_IDX, U2TXD_OUT_IDX };
         const uint32_t rx_idx_list[3] = { U0RXD_IN_IDX, U1RXD_IN_IDX, U2RXD_IN_IDX };
+        const uint32_t uart_reset[3] = { DPORT_UART_RST, DPORT_UART1_RST, DPORT_UART2_RST };
         const uint32_t tx_idx = tx_idx_list[uart_num];
         const uint32_t rx_idx = rx_idx_list[uart_num];
 
@@ -434,6 +435,9 @@ static void uart_console_configure(void)
 
         gpio_matrix_out(uart_tx_gpio, tx_idx, 0, 0);
         gpio_matrix_in(uart_rx_gpio, rx_idx, 0);
+
+        DPORT_SET_PERI_REG_MASK(DPORT_PERIP_RST_EN_REG, uart_reset[uart_num]);
+        DPORT_CLEAR_PERI_REG_MASK(DPORT_PERIP_RST_EN_REG, uart_reset[uart_num]);
     }
 #endif // CONFIG_CONSOLE_UART_CUSTOM
 

diff --git a/components/esp32/system_api.c b/components/esp32/system_api.c
index 25dddd43d1d8b61586a6f067519540e2ae47dbc6..a89fa2fb033e784e859a83fad5d22c43958cd824 100644 (file)
--- a/components/esp32/system_api.c
+++ b/components/esp32/system_api.c
@@ -327,7 +327,7 @@ void IRAM_ATTR esp_restart_noos()
 
     // Reset timer/spi/uart
     DPORT_SET_PERI_REG_MASK(DPORT_PERIP_RST_EN_REG,
-            DPORT_TIMERS_RST | DPORT_SPI01_RST | DPORT_UART_RST);
+            DPORT_TIMERS_RST | DPORT_SPI01_RST | DPORT_UART_RST | DPORT_UART1_RST | DPORT_UART2_RST);
     DPORT_REG_WRITE(DPORT_PERIP_RST_EN_REG, 0);
 
     // Set CPU back to XTAL source, no PLL, same as hard reset