Exposed important information regrading the flash bus signals

diff --git a/docs/get-started/get-started-wrover-kit.rst b/docs/get-started/get-started-wrover-kit.rst
index dc6e4edb61839ed4e7dc3497ba1da0e04a70db18..f13dffff4eab6839aeda3e45a15317707444639f 100644 (file)
--- a/docs/get-started/get-started-wrover-kit.rst
+++ b/docs/get-started/get-started-wrover-kit.rst
@@ -225,7 +225,9 @@ SPI Flash / JP13
 | 6 | CMD / GPIO11 |\r
 +---+--------------+\r
 \r
-The module's flash bus is connected to the pin header JP13 through 0-Ohm resistors R140 ~ R145. If the flash frequency needs to operate at 80 MHz, to improve integrity of the bus signals, it is recommended to desolder resistors R140 ~ R145. At this point, the module's flash bus is disconnected with the pin header JP13.\r
+.. important::\r
+\r
+    The module's flash bus is connected to the pin header JP13 through 0-Ohm resistors R140 ~ R145. If the flash frequency needs to operate at 80 MHz, to improve integrity of the bus signals, it is recommended to desolder resistors R140 ~ R145. At this point, the module's flash bus is disconnected with the pin header JP13.\r
 \r
 \r
 .. _get-started-esp-wrover-jtag-header:\r