.IX "OS-Net build tools" "cstyle" "" "\fBcstyle\fP"
.LP
.I cstyle
-inspects C source files (*.c and *.h) for common sylistic errors. It
+inspects C source files (*.c and *.h) for common stylistic errors. It
attempts to check for the cstyle documented in
\fIhttp://www.cis.upenn.edu/~lee/06cse480/data/cstyle.ms.pdf\fP.
Note that there is much in that document that
.BR "zfs (1)" ","
.BR "zdb (1)" ","
.SH "AUTHOR"
-This manual page was transvered to asciidoc by Michael Gebetsroither
+This manual page was transferred to asciidoc by Michael Gebetsroither
<gebi@grml.org> from http://opensolaris.org/os/community/zfs/ztest/
.TP
\fIenclosure_symlinks\fR <yes|no>
Additionally create /dev/by-enclosure symlinks to the disk enclosure
-sg devices using the naming scheme from from vdev_id.conf.
+sg devices using the naming scheme from vdev_id.conf.
\fIenclosure_symlinks\fR is only allowed for sas_direct mode.
.TP
\fIenclosure_symlinks_prefix\fR <prefix>
\fBvdev_cksum_errors\fR
.ad
.RS 12n
-How many checkum errors that have been detected on the vdev.
+How many checksum errors that have been detected on the vdev.
.RE
.sp
.RS 12n
If this field exists, it is an array of counters. Each entry counts bit clears
in a particular bit of a big-endian uint64 type. The first entry counts bits
-clears of the the high-order bit of the first byte, the 9th byte, etc, and the
+clears of the high-order bit of the first byte, the 9th byte, etc, and the
last entry counts clears of the low-order bit of the 8th byte, the 16th byte,
etc. This information is useful for observing a stuck bit in a parallel data
path, such as IDE or parallel SCSI.
.ad
.RS 12n
Minimum time "prescient prefetched" blocks are locked in the ARC, specified
-in ms. These blocks are meant to be prefetched fairly aggresively ahead of
+in ms. These blocks are meant to be prefetched fairly aggressively ahead of
the code that may use them. A value of \fB0\fR will default to 6000 ms.
.sp
Default value: \fB0\fR.
.ad
.RS 12n
The fraction of the hard limit used to determined the soft limit for I/O sorting
-by the sequential scan algorithm. When we cross this limit from bellow no action
+by the sequential scan algorithm. When we cross this limit from below no action
is taken. When we cross this limit from above it is because we are issuing
verification I/O. In this case (unless the metadata scan is done) we stop
issuing verification I/O and start scanning metadata again until we get to the
.TE
This feature enables additional bookmark accounting fields, enabling the
-written#<bookmark> prperty (space written since a bookmark) and estimates of
+written#<bookmark> property (space written since a bookmark) and estimates of
send stream sizes for incrementals from bookmarks.
This feature becomes \fBactive\fR when a bookmark is created and will be
Print block pointer
.It Sy d
Decompress the block. Set environment variable
-.Nm ZBD_NO_ZLE
+.Nm ZDB_NO_ZLE
to skip zle when guessing.
.It Sy e
Byte swap the block
with a send/receive operation.
The
.Sy objsetid
-can be reused (for a new datatset) after the dataset is deleted.
+can be reused (for a new dataset) after the dataset is deleted.
.It Sy origin
For cloned file systems or volumes, the snapshot from which the clone was
created.
.Pp
If set to
.Sy verify ,
-ZFS will do a byte-to-byte comparsion in case of two blocks having the same
+ZFS will do a byte-to-byte comparison in case of two blocks having the same
signature to make sure the block contents are identical. Specifying
.Sy verify
is mandatory for the
hides its partitions.
Volumes with property set to
.Sy none
-are not exposed outside ZFS, but can be snapshoted, cloned, replicated, etc,
+are not exposed outside ZFS, but can be snapshotted, cloned, replicated, etc,
that can be suitable for backup purposes.
Value
.Sy default
List project identifier (ID) and inherit flag of file(s) or directories.
.Bl -tag -width "-d"
.It Fl d
-Show the directory project ID and inherit flag, not its childrens. It will
+Show the directory project ID and inherit flag, not its children. It will
overwrite the former specified
.Fl r
option.
Print file name with a trailing NUL instead of newline (by default), like
"find -print0".
.It Fl d
-Check the directory project ID and inherit flag, not its childrens. It will
+Check the directory project ID and inherit flag, not its children. It will
overwrite the former specified
.Fl r
option.
whether the new send stream is redacted.
.sp
4. To receive an incremental send from a redacted version of the initial
-snapshot that is redacted with respect to a subect of the set of snapshots the
+snapshot that is redacted with respect to a subject of the set of snapshots the
initial snapshot was created with respect to.
A send stream from a compatible redacted dataset will contain all of the blocks
necessary to fill in any redacted data.
.sp
These restrictions are detected and enforced by \fBzfs receive\fR; a
redacted send stream will contain the list of snapshots that the stream is
-redacted with respsect to.
+redacted with respect to.
These are stored with the redacted snapshot, and are used to detect and
correctly handle the cases above. Note that for technical reasons, raw sends
and redacted sends cannot be combined at this time.