doc(rmt): fixed some typos in rmt example readme file

diff --git a/examples/peripherals/rmt_nec_tx_rx/README.md b/examples/peripherals/rmt_nec_tx_rx/README.md
index bdaa8253f3c3565764069a8eb4f634139ecaf167..85f861fdbecb37854a4ea4fbc7db52a780c3523c 100644 (file)
--- a/examples/peripherals/rmt_nec_tx_rx/README.md
+++ b/examples/peripherals/rmt_nec_tx_rx/README.md
@@ -8,7 +8,7 @@ This example uses the remote control (RMT) peripheral to transmit and receive co
 
 ### Hardware Required
 
-* A development board with ESP32 SoC (e.g., ESP32-DevKitC, ESP-WORVER-KIT, etc.)
+* A development board with ESP32 SoC (e.g., ESP32-DevKitC, ESP-WROVER-KIT, etc.)
 * A USB cable for Power supply and programming
 
 By default, this example runs a self test which assumes the TX pin (GPIO18) and RX pin (GPIO19) are _connected together_. 
@@ -77,4 +77,4 @@ NEC: RMT RCV --- addr: 0xda25 cmd: 0xeb14
     * Hardware connection is not correct: run `make monitor`, and reboot your board to see if there is any output logs.
     * The baud rate for downloading is too high: lower your baud rate in the `menuconfig` menu, and try again.
 
-For any technical queries, please open an [issue] (https://github.com/espressif/esp-idf/issues) on GitHub. We will get back to you soon.
\ No newline at end of file
+For any technical queries, please open an [issue] (https://github.com/espressif/esp-idf/issues) on GitHub. We will get back to you soon.

diff --git a/examples/peripherals/rmt_tx/README.md b/examples/peripherals/rmt_tx/README.md
index 9749381f04e8b4ec1365589ab99ae87d095a2596..3b1cf4a43e377fac551d186539235313215c0797 100644 (file)
--- a/examples/peripherals/rmt_tx/README.md
+++ b/examples/peripherals/rmt_tx/README.md
@@ -8,7 +8,7 @@ This example will shows how to configure and operate the remote control (RMT) pe
 
 ### Hardware Required
 
-* A development board with ESP32 SoC (e.g., ESP32-DevKitC, ESP-WORVER-KIT, etc.)
+* A development board with ESP32 SoC (e.g., ESP32-DevKitC, ESP-WROVER-KIT, etc.)
 * A USB cable for Power supply and programming
 * A LED, a speaker or an earphone
 
@@ -64,4 +64,4 @@ RMT Tx: Sample transmission complete
     * Hardware connection is not correct: run `make monitor`, and reboot your board to see if there is any output logs.
     * The baud rate for downloading is too high: lower your baud rate in the `menuconfig` menu, and try again.
 
-For any technical queries, please open an [issue] (https://github.com/espressif/esp-idf/issues) on GitHub. We will get back to you soon.
\ No newline at end of file
+For any technical queries, please open an [issue] (https://github.com/espressif/esp-idf/issues) on GitHub. We will get back to you soon.